Cabinet doors

I’ve gotten the doors mostly done, two of them are in place. I had a countertop of poplar, but there are two problems – one, the stain I used was way too dark with the poplar, and two, I don’t like the way the poplar grain goes from light to dark so rapidly. So, I’m redoing the countertop with 1×2 pine strips. It’ll take a while, but it’s already looking nice.

So this is what the front of the doors looks like:

doorfrontAll oak. The sides are 1×3’s, the middle is wainscotting in 3 1/2 wide strips. Yes, that’s normally the stuff you put on walls if you want wooden paneling. The back of the door is flat:

doorbackYou can see the wainscotting doesn’t cover the whole back surface. The 1×3’s will be flush against the cabinet front, the wainscotting fits inside each door opening. Here’s what it looks like with the two outside doors attached:

doorson2

That’s a bit dark, so here’s a closeup of the right door in place:

dooronclose

The middle door is still getting it’s wainscotting glued on, so it won’t be attached until tomorrow at the earliest. The light boards you see on top are the new countertop being built, the upright on the upper right is part of the old countertop (still in place, but not secured). You can see the old countertop just above the doors – I wanted a lot more contrast between the oak and the countertop. Once I finish assembling the countertop, I’ll have that contrast, since I’ll be using a very incredibly almost insanely light stain on it before glazecoating it. That will probably take me until the middle of next week at the earliest, simply because it takes so long for each pine strip to set enough to unclamp it and put on the next one.

Once all that’s done, I’m ready to buy the flooring. Woot!

Leave a Reply